AT-EL01 · Electrical machines
DC Motor Speed Control Using PWM
Turn a knob to change the speed of a DC motor smoothly from stop to full speed.
- Suits
- Sem 3–6
- Branches
- EEE, Mechatronics
- Type
- Hardware model
How it works
Instead of lowering the voltage, the circuit switches the motor supply on and off thousands of times a second through a MOSFET. The longer the on-time in each cycle, the higher the average voltage and the faster the motor runs. Turning the knob changes this on-time from 0 to 100 percent. Speed is raised gradually at start so the motor does not jerk.
What it does
- PWM control
- Speed shown in percent
- Soft start
Main parts
Arduino or 555, MOSFET driver, DC motor
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-EL02DC Motor Direction ControlRun a DC motor forward, reverse or stop with push buttons using relay switching.
- AT-EL03Closed-Loop Motor Speed Control with RPM DisplayThe controller holds the set speed even when the load changes and shows live RPM.
- AT-EL04Star-Delta Starter ModelShows how a motor starts in star and shifts to delta after a set time, using relays and a timer.
- AT-EL07Stepper Motor Position ControlEnter an angle on the keypad and the stepper motor turns exactly to that position.