AT-BE10 · Measurement
Digital Voltmeter and Ammeter
Measures DC voltage and current and shows both on an LCD.
- Suits
- Sem 3–6
- Branches
- ECE, EEE
- Type
- Hardware model
How it works
The voltage being measured is brought down to a safe level by a resistor divider and read by the Arduino. The current flows through an ACS712 sensor, which gives a voltage proportional to the current without any direct electrical contact. The Arduino converts both readings to volts and amps, multiplies them to get watts and shows all three on the LCD.
What it does
- 0 to 25V range
- Current up to 5A
- Power calculation
Main parts
Arduino, voltage sensor, ACS712, LCD
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE01LED Chaser Using 555 and CD4017Ten LEDs light one after another in a running pattern, with a knob to change the speed.
- AT-BE02Clap Switch Using 555 TimerClap once to switch a lamp on and clap again to switch it off.
- AT-BE03Touch-Activated AlarmAn alarm rings when someone touches a metal plate or door handle.
- AT-BE04Fire Alarm Using ThermistorA thermistor senses a rise in temperature and triggers a buzzer.