AT-EE19 · MATLAB/Simulink
DSTATCOM for Reactive Power Compensation (Simulation)
A Simulink model showing how a DSTATCOM improves power factor and voltage at the load.
- Suits
- Sem 7–8
- Branches
- EEE
- Type
- Software
How it works
The model has a source, a line and a load that draws reactive power, which lowers the power factor and the load voltage. A DSTATCOM, which is an inverter with a DC capacitor, is connected at the load point. Its PI controller makes it supply the reactive current the load needs. Waveforms with and without the DSTATCOM show the improvement.
What it does
- PI controller
- Before and after waveforms
- THD results
Built with
MATLAB/Simulink
What you get
- Working software with full source code
- Steps to install and run it on your laptop
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- Features are as listed here. Anything extra is quoted separately.
- Runs on a normal laptop unless we tell you otherwise.
- Full reports and PPTs are not included.
Similar projects
- AT-EE18Grid-Connected Solar PV with MPPT (Simulation)A Simulink model of a PV array feeding the grid through an inverter with MPPT control.
- AT-EE20EV Charging Optimisation in a Distribution System (Simulation)A model that schedules EV charging to reduce peak load on a feeder.
- AT-EE01Solar Power Monitoring with IoTShows live voltage, current, power and energy from a solar panel on a phone.
- AT-EE02Hybrid Solar-Wind Power with Auto SwitchingDraws power from solar or wind, whichever is available, and charges a battery.