AT-EE13 · Power
Automatic Power Factor Correction
Measures power factor and switches capacitors in to bring it close to unity.
- Suits
- Sem 7–8
- Branches
- EEE
- Type
- Hardware model
How it works
A current transformer and a potential transformer feed samples of the load current and voltage to the controller. It measures the time gap between the two waveforms crossing zero, which gives the phase angle and the power factor. If the power factor is low, relays connect capacitors in steps until it is close to unity. The display shows the value before and after.
What it does
- PF measurement
- Stepped capacitor bank
- Before and after display
Main parts
Controller, CT and PT, relays, capacitors
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE07Battery Charger with Auto Cut-OffCharges a 12V battery and stops by itself when the battery is full.
- AT-BE08Automatic Emergency LightAn LED light turns on by itself during a power cut and recharges when power returns.
- AT-BE09Simple 12V DC to AC InverterConverts 12V battery power into AC to run a small lamp or charger.
- AT-EE14Smart Power Management with Priority LoadsWhen total load crosses the limit, the least important loads are switched off first and restored later.