AT-BE07 · Power
Battery Charger with Auto Cut-Off
Charges a 12V battery and stops by itself when the battery is full.
- Suits
- Sem 3–6
- Branches
- ECE, EEE
- Type
- Hardware model
How it works
The transformer steps the mains down, a rectifier converts it to DC and a regulator IC holds a steady charging voltage. While charging, a sensing stage watches the battery voltage. When it reaches the full-charge level, the circuit operates a relay that disconnects the charger, and the indicator changes from charging to full. A diode protects the circuit if the battery is connected the wrong way round.
What it does
- Full-charge cut-off
- Charging indicator
- Reverse-polarity protection
Main parts
Regulator IC, relay, transformer
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE08Automatic Emergency LightAn LED light turns on by itself during a power cut and recharges when power returns.
- AT-BE09Simple 12V DC to AC InverterConverts 12V battery power into AC to run a small lamp or charger.
- AT-EE13Automatic Power Factor CorrectionMeasures power factor and switches capacitors in to bring it close to unity.
- AT-EE14Smart Power Management with Priority LoadsWhen total load crosses the limit, the least important loads are switched off first and restored later.