AT-EL05 · Protection
Motor Overload Protection System
Measures motor current and trips the supply when it stays above the safe limit.
- Suits
- Sem 3–6
- Branches
- EEE
- Type
- Hardware model
How it works
The motor current passes through an ACS712 sensor, and the Arduino shows the value on the LCD. If the current stays above the safe limit for more than a short delay, the Arduino opens the relay and the motor stops. The delay prevents a trip on the brief high current every motor draws at starting. The motor stays off until the reset button is pressed.
What it does
- Current sensing
- Trip and reset
- Current on LCD
Main parts
Arduino, ACS712, relay, LCD
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE06Over-Voltage and Under-Voltage ProtectionCuts off the load when the supply goes above or below safe limits and reconnects when it is normal.
- AT-EL06Phase Failure and Phase Reversal ProtectionStops a three-phase motor if a phase is missing or the sequence is wrong.
- AT-EL14Transformer Overload and Temperature ProtectionDisconnects the load when a small transformer overheats or is overloaded.
- AT-EE12Underground Cable Fault LocatorShows the distance to a cable fault in kilometres on a display.