AT-EL14 · Protection
Transformer Overload and Temperature Protection
Disconnects the load when a small transformer overheats or is overloaded.
- Suits
- Sem 5–6
- Branches
- EEE
- Type
- Hardware model
How it works
A temperature sensor is fixed on the body of a small transformer and a current sensor measures the load on it. The Arduino shows both readings on the LCD and compares them with safe limits. If the transformer gets too hot or the load current is too high, the relay disconnects the load. Supply is restored only after the readings return to normal.
What it does
- Temperature and current sensing
- Automatic trip
- LCD status
Main parts
Arduino, temperature sensor, ACS712, relay
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE06Over-Voltage and Under-Voltage ProtectionCuts off the load when the supply goes above or below safe limits and reconnects when it is normal.
- AT-EL05Motor Overload Protection SystemMeasures motor current and trips the supply when it stays above the safe limit.
- AT-EL06Phase Failure and Phase Reversal ProtectionStops a three-phase motor if a phase is missing or the sequence is wrong.
- AT-EE12Underground Cable Fault LocatorShows the distance to a cable fault in kilometres on a display.