AT-BE06 · Protection
Over-Voltage and Under-Voltage Protection
Cuts off the load when the supply goes above or below safe limits and reconnects when it is normal.
- Suits
- Sem 3–6
- Branches
- ECE, EEE
- Type
- Hardware model
How it works
A small transformer and rectifier produce a low DC voltage that rises and falls with the mains. This sample goes to two comparators, one set for the upper limit and one for the lower limit. While the supply is in between, the relay stays on and the load gets power. If the supply goes outside either limit, the comparator output changes, the relay drops and the load is disconnected until the supply is normal again.
What it does
- Two set points
- Relay cut-off
- Status LEDs
Main parts
Comparator IC, relay, transformer
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-EL05Motor Overload Protection SystemMeasures motor current and trips the supply when it stays above the safe limit.
- AT-EL06Phase Failure and Phase Reversal ProtectionStops a three-phase motor if a phase is missing or the sequence is wrong.
- AT-EL14Transformer Overload and Temperature ProtectionDisconnects the load when a small transformer overheats or is overloaded.
- AT-EE12Underground Cable Fault LocatorShows the distance to a cable fault in kilometres on a display.