AT-BE12 · Arduino
Password-Based Door Lock
A keypad lock that opens only with the correct code and raises an alarm after three wrong tries.
- Suits
- Sem 3–4
- Branches
- ECE, EEE, Mechatronics
- Type
- Hardware model
How it works
You type the code on a 4x4 keypad and the Arduino compares it with the code stored in its memory. If it matches, a servo or solenoid pulls the latch open for a few seconds and then locks again. If it is wrong, the LCD shows an error, and three wrong attempts in a row start the alarm. The password can be changed from the keypad after entering the old one.
What it does
- Changeable password
- Wrong-attempt alarm
- Servo or solenoid latch
Main parts
Arduino, keypad, servo, LCD
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-FY04Smart Dustbin with Automatic LidThe lid opens when a hand comes near and closes by itself, so nobody touches a dirty bin.
- AT-FY05Automatic Hand Sanitizer DispenserHold a hand under the nozzle and a small pump gives a measured amount of sanitizer without any contact.
- AT-FY06Automatic Plant Watering SystemA soil moisture sensor switches the pump on when the soil is dry and off when it is wet enough.
- AT-FY08Smart Parking AssistantGreen, yellow and red lights tell the driver how close the car is to the wall, with a buzzer at the stop point.