AT-BE18 · Arduino
Room Light Controller with Visitor Counter
Counts people entering and leaving a room and switches the light off when the room is empty.
- Suits
- Sem 3–6
- Branches
- ECE, EEE
- Type
- Hardware model
How it works
Two IR sensors are fixed one after the other at the door. The order in which they are blocked tells the Arduino the direction: outer then inner means someone came in, inner then outer means someone went out. The count goes up or down accordingly and is shown on the LCD. The light is on while the count is above zero and switches off when the last person leaves.
What it does
- Two-way counting
- Auto light control
- Count on display
Main parts
Arduino, IR sensors, relay, LCD
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-FY04Smart Dustbin with Automatic LidThe lid opens when a hand comes near and closes by itself, so nobody touches a dirty bin.
- AT-FY05Automatic Hand Sanitizer DispenserHold a hand under the nozzle and a small pump gives a measured amount of sanitizer without any contact.
- AT-FY06Automatic Plant Watering SystemA soil moisture sensor switches the pump on when the soil is dry and off when it is wet enough.
- AT-FY08Smart Parking AssistantGreen, yellow and red lights tell the driver how close the car is to the wall, with a buzzer at the stop point.